HAL: Difference between revisions

From MAGLab
Jump to navigation Jump to search
m (→‎2021: Added details about the LT3960)
m (→‎History: Apparently, temperature sensor network restarts were implemented in 2021)
Line 14: Line 14:
HAL GUI updated with better fan controls
HAL GUI updated with better fan controls
* Still not feature-complete
* Still not feature-complete
Temperature Network Restart Added (problem report not written)
* Restarts the HAL temperature sensor network when outages or over-current conditions are detected
* MIC2090 chip used.  100mA current on the 5V line.


Grafana Interface Added
Grafana Interface Added
Line 34: Line 30:
* the termination resistors are set to the 100 ohm impedance of Ethernet rather than the standard 120 ohm CAN termination
* the termination resistors are set to the 100 ohm impedance of Ethernet rather than the standard 120 ohm CAN termination


Temperature sensor network restart under fault
Temperature Network Restart Added (problem report not written)
* Restarts the HAL temperature sensor network when outages or over-current conditions are detected
* MIC2090 chip used.  100mA current on the 5V line.


=== 2020 ===
=== 2020 ===

Revision as of 01:41, 25 July 2022

HAL is MAG Laboratory's motion, door, and open status monitor.

HAL block diagram


Design

HAL is based on the raspberry-pi (one) model B and uses the PI's GPIO pins to interface with the outside world.

There is a hardware design document on Google Drive.


History

2022

HAL GUI updated with better fan controls

  • Still not feature-complete

Grafana Interface Added

InfluxDB Logging Started

2021

Internal HAL GUI prototype released (C#, mono)

Fan (motor) temperature sensor attached

LT3960 differential one-wire implemented.

  • using 5V power directly connected to VCC instead of the 3v3 internal LDO
  • the termination resistors are set to the 100 ohm impedance of Ethernet rather than the standard 120 ohm CAN termination

Temperature Network Restart Added (problem report not written)

  • Restarts the HAL temperature sensor network when outages or over-current conditions are detected
  • MIC2090 chip used. 100mA current on the 5V line.

2020

Sensor network expanded

  • ShopB
    • Motion
    • Temp
  • Outdoor Temp
  • ConfRm
    • Motion
    • Temp
  • ElecRm
    • Motion
    • Temp

Internal HAL GUI implemented (python + pyside2)

Web Synoptic View Implemented

HAL synoptic view 2020

HAL internal mounting board added.

HAL hardware 2020

HAL interface & protection board added (See HAL-2 in the Problem Reports)

2017

HAL was created??? [Needs Confirmation]

Problem Reports

HAL-1 : "Main Door" does not describe the door being monitored

HAL-2 : Haldor Board is not Sufficiently Skookum for Safety

HAL-3 : A synoptic view should be implemented

HAL-4 : An Auto Updating Feature Should be Implemented