HAL: Difference between revisions

From MAGLab
Jump to navigation Jump to search
m (updated the 2021 history)
Line 11: Line 11:
Internal HAL GUI prototype released (C#, mono)
Internal HAL GUI prototype released (C#, mono)
* [[12"_Axial_Ventilation_Fan]] GUI implemented
* [[12"_Axial_Ventilation_Fan]] GUI implemented
** Fan (motor) temperature sensor attached
* LT3960 differential one-wire implemented  
* LT3960 differential one-wire implemented  
* Temperature sensor network restart under fault
* Temperature sensor network restart under fault

Revision as of 13:26, 18 December 2021

HAL is MAG Laboratory's motion, door, and open status monitor.

Design

HAL is based on the raspberry-pi (one) model B and uses the PI's GPIO pins to interface with the outside world.

There is a hardware design document on Google Drive.


History

2021

Internal HAL GUI prototype released (C#, mono)

  • 12"_Axial_Ventilation_Fan GUI implemented
    • Fan (motor) temperature sensor attached
  • LT3960 differential one-wire implemented
  • Temperature sensor network restart under fault

2020

Sensor network expanded

  • ShopB
    • Motion
    • Temp
  • Outdoor Temp
  • ConfRm
    • Motion
    • Temp
  • ElecRm
    • Motion
    • Temp

Internal HAL GUI implemented (python + pyside2)

Web Synoptic View Implemented

HAL synoptic view 2020

HAL internal mounting board added.

HAL hardware 2020

HAL interface & protection board added (See HAL-2 in the Problem Reports)

2017

HAL was created??? [Needs Confirmation]

Problem Reports

HAL-1 : "Main Door" does not describe the door being monitored

HAL-2 : Haldor Board is not Sufficiently Skookum for Safety

HAL-3 : A synoptic view should be implemented

HAL-4 : An Auto Updating Feature Should be Implemented