BLu Delta 3D Printer: Difference between revisions
No edit summary |
No edit summary |
||
| Line 24: | Line 24: | ||
== History == | == History == | ||
=== Head clogs === | === Head clogs === | ||
The printer has been clogged at least five times. Every clog was because of incorrect heat application and has required | The printer has been clogged at least five times. Every clog was because of incorrect heat application and has required specialty repairs. | ||
Revision as of 20:00, 10 September 2018
BLu Delta is a RepRap Kossel made by Brandon Lu.
General Advice and Precautions
It is by no means safe to operate this delta if the user wishes to consider himself a sane and rational human being.
Operating this delta would create a situation in which the user ceases to be a sane and rational human being. The user may become a robot. Or you may lose your sanity.
Either way, ask before using. The last time somebody used without asking, the extruder was clogged and needed to be unclogged through a two-hour process.
Precautions
Do not let the extruder heat up without a powered fan. The recommended fan setting is always above 20%. The printer gives fan commands in pulse-width-modulated counts ranging from 0 to 255. Always set the printer to a count of 51 or more counts when the extruder is heated up or you are expecting it to heat up.
Configuration
TODO
Slic3r
TODO
Cura
TODO
Materials
History
Head clogs
The printer has been clogged at least five times. Every clog was because of incorrect heat application and has required specialty repairs.